Chevrolet 2001 Impala Bedienungshandbuch PDF herunterladen (Seite 117)

2-47

Turn Signal On Chime

If you leave either one of your turn signals on and

drive more than 3/4 mile (1.2 km), a chime will sound

to alert you.

Headlamp High/Low-Beam Changer

To change your headlamps from low beams to high

beams, or high to low, pull the multifunction lever all

the way toward you. Then release it.

When the high beams are

on, this blue light on the

instrument panel cluster

also will be on.

This light works only when the ignition key is in the ON

position, and your fog lamps (if equipped) will not be

illuminated when your high beams are on.

Flash-to-Pass Feature

This feature lets you use your high-beam headlamps to

signal the driver in front of you that you want to pass.

It works even if your headlamps are off.

To use it, pull the turn signal lever toward you a little,

but not so far that you hear a click.

If the headlamps are off or the low beams are on, the

high

-beam headlamps will turn on. They’ll stay on

as long as you hold the lever toward you and the

high

-beam indicator on the dash will come on.

Release the lever to turn the high

-beam headlamps off.

Windshield Wipers

When the ignition key is in the ACC or ON position,

you can control the windshield wipers by turning the

band marked WIPER. For a single wiping cycle, turn the

band to MIST. Hold it there until the wipers start, then

let go. The wipers will stop after one cycle. If you want

more cycles, hold the band on MIST longer.

For steady wiping at low speed, turn the band to LO.

For high

-speed wiping, turn the band further, to HI.

To stop the wipers, turn the band to OFF.

1 2 ... 112 113 114 115 116 117 118 119 120 121 122 ... 391 392

Keine Kommentare

Chevrolet 2001 Impala Bedienungshandbuch Seite 117