Chevrolet 2004 Tahoe Spezifikationen PDF herunterladen (Seite 184)

Automatic Operation

AUTO (Automatic): When automatic operation is

active the system will control the inside temperature,

the air delivery, and the fan speed.

Use the steps below to place the entire system in

automatic mode:

1. Press the AUTO button.

When AUTO is selected, the display will change to

show the current driver’s set temperature, delivery

mode and fan speed. Press the AUTO button again

within ﬁve seconds to display the passenger’s set

temperature.

If the driver and passenger’s temperature settings

are not the same, the opposite side temperature

setting will be displayed for an additional ﬁve

seconds. To make the passenger’s temperature the

same as the driver’s press and hold the AUTO

button for about four seconds.

When AUTO is selected, the air conditioning

operation and air inlet will be automatically

controlled. The air conditioning compressor will run

when the outside temperature is over about

40°F (4°C). The air inlet will normally be set to

outside air. If it’s hot outside, the air inlet may

automatically switch to recirculate inside air to help

quickly cool down your vehicle. The light on the

button will illuminate in recirculation.

2. Set the driver’s and passenger’s temperature.

To ﬁnd your comfort setting, start with a 74°F (23°C)

temperature setting and allow about 20 minutes

for the system to regulate. Turn the driver’s or

passenger’s side temperature knob to adjust the

temperature setting as necessary. If you choose the

temperature setting of 60°F (15°C) the system

will remain at the maximum cooling setting. If you

choose the temperature setting of 90°F (32°C)

the system will remain at the maximum heat setting.

Choosing either maximum setting will not cause

the vehicle to heat or cool any faster.

Be careful not to cover the sensor located on the

top of the instrument panel near the windshield.

This sensor regulates air temperature based on

sun load, and also turns on your headlamps.

To avoid blowing cold air in cold weather, the system

will delay turning on the fan until warm air is available.

The length of delay depends on the engine coolant

temperature. Pressing the fan switch will override this

delay and change the fan to a selected speed.

9(Off): Press this button to turn off the entire climate

control system. Outside air will still enter the vehicle, and

will be directed to the ﬂoor. This direction can be changed

by pressing the mode button. The temperature can also

be adjusted using either temperature knob. Press the up

or down arrows on the fan switch, the defrost button, the

AUTO button, or the air conditioning button to turn the

system on when it is off.

3-28

1 2 ... 179 180 181 182 183 184 185 186 187 188 189 ... 547 548

Kommentare zu diesen Handbüchern

Keine Kommentare

Chevrolet 2004 Tahoe Spezifikationen Seite 184

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Auto Alarmanlage Chevrolet 2004 Tahoe