Chevrolet 2006 impala Spezifikationen PDF herunterladen (Seite 103)

SECOND (2): This position gives you more power but

lower fuel economy than THIRD (3). You can use

SECOND (2) on hills. It can help control your speed as

you go down steep mountain roads. You would also

then want to use your brakes off and on.

Notice: Driving in SECOND (2) for more than

25 miles (40 km) or at speeds over 55 mph (90 km/h)

may damage the transaxle. Also, shifting into

SECOND (2) at speeds above 65 mph (105 km/h) can

cause damage. Drive in THIRD (3) or AUTOMATIC

OVERDRIVE (D) instead of SECOND (2).

FIRST (1): This position gives you even more power,

but lower fuel economy than SECOND (2). You can use

it on very steep hills, or in deep snow or mud. If the

shift lever is in FIRST (1), the transaxle will not shift into

ﬁrst gear until the vehicle is going slowly enough.

Notice: Spinning the tires or holding the vehicle in

one place on a hill using only the accelerator pedal

may damage the transaxle. If you are stuck, do

not spin the tires. When stopping on a hill, use

the brakes, or parking brake to hold the vehicle

in place.

Parking Brake

The parking brake is

located to the left of the

brake pedal, near the

driver’s door.

To set the parking brake, hold the brake pedal down

with your right foot. Push down the parking brake pedal

with your left foot.

To release the parking brake, hold the brake pedal

down with your right foot and push the parking brake

pedal with your left foot. When you lift your left foot,

the parking brake pedal will follow it to the released

position.

2-27

1 2 ... 98 99 100 101 102 103 104 105 106 107 108 ... 389 390

Keine Kommentare

Chevrolet 2006 impala Spezifikationen Seite 103