3.
Pull the headlamp out
of
the assembly. Remove the
wiring connector from the headlamp socket by lifting
the plastic locking tabs
on
the connector and pulling
it
from
the
socket.
4.
Check the new headlamp again. The number on the
lamp must match the number of the headlamp being
replaced. The letter
U
or
L
must also match.
5.
Plug the wiring connector into the headlamp socket.
Snap the locking tabs onto the socket.
6.
Place the new headlamp in the headlamp assembly.
The socket must be pointing in the same direction
the socket on the burned out bulb was.
7.
Insert the tabs on the aiming ring
into
the tabs in the
headlamp assembly.
8.
Hold the aiming ring closed, insert the screws at the
end
of
the ring. Tighten the screws until the aiming
ring touches the plastic nuts
on
both the top and
bottom.
Do
not overtighten.
Do
not damage the
vertical aiming bubble.
6-43
Kommentare zu diesen Handbüchern