Chevrolet 1999 Prizm Bedienungshandbuch PDF herunterladen (Seite 103)

yellowblue

2-33

Resuming a Set Speed

Suppose you set your cruise control at a desired speed

and then you apply the brake. This, of course, shuts off

the cruise control. But you don’t need to reset it.

Unless you’re going about 25 mph (40 km/h) or less or

you slowed down to 10 mph (16 km/h) less than your

preset speed, you can press the lever up to RES/ACC

(Resume/Accelerate) briefly. You’ll go right back up to

your chosen speed and stay there.

If your preset speed cancels out when it shouldn’t,

there may be a problem with your cruise control. See

your dealer.

Increasing Speed While Using Cruise Control

There are two ways to go to a higher speed:

Use the accelerator pedal to get to the higher speed.

Push the lever to SET/COAST and hold it briefly.

Release the lever and the accelerator pedal. You’ll

now cruise at the higher speed.

Move the cruise lever from ON to RES/ACC. Hold it

there until you get up to the speed you want, and

then release the lever. (To increase your speed in

very small amounts, move the lever to RES/ACC

briefly and then release it. Each time you do this,

your vehicle will go about 1 mph (1.6 km/h) faster.)

Reducing Speed While Using Cruise Control

There are two ways to reduce your speed while using

cruise control:

Push and hold the lever to SET/COAST until you

reach the lower speed you want, then release it.

To slow down in very small amounts, push the lever

briefly. Each time you do this, you’ll go 1 mph

(1.6 km/h) slower.

Passing Another Vehicle While Using Cruise Control

Use the accelerator pedal to increase your speed. When

you take your foot off the pedal, your vehicle will slow

down to the cruise control speed you set earlier.

1 2 ... 98 99 100 101 102 103 104 105 106 107 108 ... 351 352

Keine Kommentare

Chevrolet 1999 Prizm Bedienungshandbuch Seite 103