Chevrolet 2000 Prizm Bedienungshandbuch PDF herunterladen (Seite 100)

2-28

Turn Signal and Lane Change Indicator

The turn signal has two upward (for right) and two

downward (for left) positions. These positions allow

you to signal a turn or a lane change.

To signal a turn, move the lever all the way up

or down. When the turn is finished, the lever will

return automatically.

An arrow on the instrument

panel cluster will flash in

the direction of the turn

or lane change.

To signal a lane change, just raise or lower the lever

until the arrow starts to flash. Hold it there until you

complete your lane change. The lever will return by

itself when you release it.

If you signal a turn or a lane change and notice the

arrow flashing rapidly, a signal bulb may be burned

out and other drivers won’t see your turn signal.

If a bulb is burned out, have it replaced to help avoid

an accident. If the arrows don’t go on at all when you

signal a turn, check for burned

-out bulbs and then check

the fuse (see “Fuses and Circuit Breakers” in the Index).

Headlamp High/Low Beam Changer

First, you must have the

headlamps on. For high

beams, push the turn signal

lever away from you. When

the high beams are on, this

light on the instrument panel

cluster also will be on.

It will go off when you switch to the low beams. To switch

back to low beams, pull the lever toward you.

Flash-to-Pass

With the lever in the low-beam position, pull the

lever toward you to momentarily switch to high beams

(to signal that you are going to pass). If you have the

headlamps on when you release the lever, they will

return to the low beams.

1 2 ... 95 96 97 98 99 100 101 102 103 104 105 ... 335 336

Keine Kommentare

Chevrolet 2000 Prizm Bedienungshandbuch Seite 100