Chevrolet 2006 Avalanche Spezifikationen PDF herunterladen (Seite 190)

Automatic Operation

AUTO (Automatic): When automatic operation is

active the system will control the inside temperature, the

air delivery, and the fan speed.

Use the steps below to place the entire system in

automatic mode:

1. Press the AUTO button.

When AUTO is selected, the display will change to

show the current driver’s set temperature, delivery

mode and fan speed. Press the AUTO button again

within ﬁve seconds to display the passenger’s set

temperature.

If the driver’s and passenger’s temperature settings

are the same when AUTO is pressed, the

temperature setting and both arrows will be displayed

for ﬁve seconds along with the automatic air delivery

mode and fan speed. After the ﬁve-second update,

the display will change to show the temperature

setting, both arrows and AUTO.

If the driver’s and passenger’s temperature

settings are not the same, the opposite side

temperature setting will be displayed for an

additional ﬁve seconds. To make the passenger’s

temperature the same as the driver’s press and hold

the AUTO button for about four seconds.

When auto is selected, the air conditioning operation

and air inlet will be automatically controlled. The air

conditioning compressor will run when the outside

temperature is over about 40°F (4°C). The air inlet

will normally be set to outside air. If it’s hot outside,

the air inlet may automatically switch to recirculate

inside air to help quickly cool down your vehicle. The

light on the button will illuminate in recirculation.

2. Set the driver’s and passenger’s temperature.

To ﬁnd your comfort setting, start with a 74°F (23°C)

temperature setting and allow about 20 minutes for

the system to regulate. Turn the driver’s or

passenger’s side temperature knob to adjust the

temperature setting as necessary. If you choose the

temperature setting of 60°F (15°C) the system will

remain at the maximum cooling setting. If you choose

the temperature setting of 90°F (32°C) the system

will remain at the maximum heat setting. Choosing

either maximum setting will not cause the vehicle to

heat or cool any faster.

Be careful not to cover the sensor located on the

top of the instrument panel near the windshield. This

sensor regulates air temperature based on sun

load, and also turns on your headlamps.

To avoid blowing cold air in cold weather, the

system will delay turning on the fan until warm air is

available. The length of delay depends on the

engine coolant temperature. Pressing the fan switch

will override this delay and change the fan to a

selected speed.

3-24

1 2 ... 185 186 187 188 189 190 191 192 193 194 195 ... 521 522

Kommentare zu diesen Handbüchern

Keine Kommentare

Chevrolet 2006 Avalanche Spezifikationen Seite 190

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Autositz Chevrolet 2006 Avalanche