Chevrolet 2006 impala Spezifikationen PDF herunterladen (Seite 279)

When the engine is cold, the coolant level should be at

or above the cold ﬁll line on the coolant recovery

tank. To check the coolant level, look for the cold ﬁll line

on the side of the coolant recovery tank that faces the

engine. If the level is not correct, there may be a leak at

the pressure cap or in the radiator hoses, heater

hoses, radiator, water pump, or somewhere else in the

cooling system.

{CAUTION:

Heater and radiator hoses, and other engine

parts, can be very hot. Do not touch them. If

you do, you can be burned.

Do not run the engine if there is a leak. If you

run the engine, it could lose all coolant. That

could cause an engine ﬁre, and you could be

burned. Get any leak ﬁxed before you drive

the vehicle.

If there seems to be no leak, with the engine on, check

to see if the electric engine cooling fans are running.

If the engine is overheating, the fans should be running.

If the fans are not running, your vehicle needs service.

Notice: Engine damage from running your

engine without coolant is not covered by your

warranty. See Overheated Engine Protection

Operating Mode on page 5-31 for information on

driving to a safe place in an emergency.

Notice: Using coolant other than DEX-COOL

may

cause premature engine, heater core or radiator

corrosion. In addition, the engine coolant may

require changing sooner, at 30,000 miles (50 000 km)

or 24 months, whichever occurs ﬁrst. Any repairs

would not be covered by your warranty. Always use

DEX-COOL

(silicate-free) coolant in your vehicle.

5-33

1 2 ... 274 275 276 277 278 279 280 281 282 283 284 ... 389 390

Keine Kommentare

Chevrolet 2006 impala Spezifikationen Seite 279