Chevrolet 1999 S10 Pickup Bedienungshandbuch Seite 282

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 381
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 281
6-40
Two-Piece Front Turn Signal
Lamp Assembly
1. Remove the headlamp assembly as shown under
“Two
-Piece Composite Headlamp System” earlier in
this section.
2. Locate the locking tabs
on the assembly.
Squeeze the tabs
together and push that
end of the assembly out
while holding the tabs.
The assembly will
swing out.
3. Unplug the electrical connector.
4. Turn the harness bulb socket counterclockwise to
remove it. Pull the bulb straight out to remove it
from the socket.
5. Push the new bulb into the socket until it snaps
into place.
6. Put the socket into the lamp assembly and turn it
clockwise until it is tight.
7. To replace the assembly, snap the outboard end of
the lamp assembly back into the vehicle. Then swing
the assembly in and snap it into place.
8. Replace the headlamp assembly. Install the two
retaining clips.
Seitenansicht 281
1 2 ... 277 278 279 280 281 282 283 284 285 286 287 ... 380 381

Kommentare zu diesen Handbüchern

Keine Kommentare