Chevrolet 2010 Camaro Bedienungsanleitung PDF herunterladen (Seite 292)

TPMS Sensor Matching

Process

Each TPMS sensor has a unique

identiﬁcation code. Any time you

replace one or more of the TPMS

sensors or rotate your vehicle’s tires,

the identiﬁcation codes need to be

matched to the new tire/wheel

position. The sensors are matched

to the tire/wheel positions in the

following order: driver side front tire,

passenger side front tire, passenger

side rear tire, and driver side rear

tire using a TPMS diagnostic tool.

See your dealer/retailer for service.

The TPMS sensors can also be

matched to each tire/wheel position

by increasing or decreasing the

tire’s air pressure. If increasing the

tire’s air pressure, do not exceed

the maximum inﬂation pressure

indicated on the tire’s sidewall.

To decrease the tire’s air-pressure

use the pointed end of the valve

cap, a pencil-style air pressure

gage, or a key.

You have two minutes to match

the ﬁrst tire/wheel position, and

ﬁve minutes overall, to match all

four tire/wheel positions. If it takes

longer than two minutes, to match

the ﬁrst tire and wheel, or more than

ﬁve minutes to match all four tire

and wheel positions, the matching

process stops and you need to

start over.

The TPMS matching process is

outlined below:

1. Set the parking brake.

2. Turn the ignition switch to

ON/RUN with the engine off.

3. Go to the TPM vehicle

information screen on the DIC.

See Driver Information Center

(DIC) on page 4-27. Press set to

relearn the sensors. The horn

sounds twice to signal the

receiver is in relearn mode and

Tire Learning Active message

displays on the DIC screen.

4. Start with the driver side

front tire.

5. Remove the valve cap from

the valve stem. Activate the

TPMS sensor by increasing or

decreasing the tire’s air pressure

for 10 seconds, or until a horn

chirp sounds. The horn chirp,

which can take up to 30 seconds

to sound, conﬁrms that the TPMS

sensor identiﬁcation code has

been matched to this tire position.

6. Proceed to the passenger

side front tire, and repeat

the procedure in Step 5.

7. Proceed to the passenger

side rear tire, and repeat

the procedure in Step 5.

8. Proceed to the driver side rear

tire, and repeat the procedure

in Step 5.

9. After hearing the conﬁrming horn

chirp, for the driver side rear tire,

the horn sounds two more times

to signal the tire learning mode is

no longer active. Turn the ignition

switch to LOCK/OFF.

9-60 Vehicle Care

1 2 ... 287 288 289 290 291 292 293 294 295 296 297 ... 371 372

Kommentare zu diesen Handbüchern

Keine Kommentare