Senrice
&
Appearance
Cam
7.
Lift up on each of the two latches at the bottom of the cover.
-
8.
Remove the two screws at the engine cover using a long handled
screwdriver. The screws are not suppose to come out of the cover, only
from the front of dash. When removing the cover, be careful not to
damage the instrument panel or the trim.
9.
Grasp the bottom
of
the cover and slide it backwards. Then, lift
it
up
and out of the vehicle.
To
Install the Engine Cover:
1.
Lift the engine cover into the vehicle and slide
it
all the way forward.
Make sure the rubber seal is over the latches.
2.
Install the two screws at the engine cover.
Do
not tighten the screws all
3.
Press down on each
of
the two latches at the bottom of the cover.
the way.
Make sure they are secure.
4.
Tighten the two screws at the engine cover.
5.
Turn the bracket into position and install the bolt. Tighten the nut at the
6.
Put the heater duct over the engine cover studs. Push up on the duct
other end of the bracket.
gently until
it
snaps into place.
7.
Reconnect the electrical connector for the cigarette lighter.
6-1
8
Kommentare zu diesen Handbüchern