Chevrolet CORVETTE Z06 - 2010 Bedienungsanleitung PDF herunterladen (Seite 10)

Part #1572 & 1573

Brochure #63-1572

Rev. 1/11 - AJ/mc

Edelbrock GM LS7 Supercharger System for

2006 - 2010 Z06 Corvettes

Installation Instructions

Page 9

11. Remove the five 7mm and two 10mm nuts retaining

the fascia from below.

12. Remove four body pins (two on each side) by

reaching up through the bottom of the fascia.

13. Place multiple layers of masking tape on the nose of

the hood as well as the portion of the front fascia directly

below the hood to protect from damage during removal.

14. The sides of the fascia can be pulled away from the

clips holding it in place, then down off the studs. The

center section must be pulled up and over the nose

section, and the whole assembly pulled straight off and

set aside.

15. Disconnect the Mass Airflow Sensor connector.

16. Disconnect the PCV tube from the air inlet tube.

17. Use a flat head screwdriver to loosen all three air

inlet worm clamps.

18. Pull out the splash shield above the air filter housings

then release the four clamps retaining the air box lids and

remove them along with the filters.

19. Compress the flex tube to remove it from the throttle

body and the MAF sensor then remove the sensor.

Remove the airbox assembly by lifting it off the retaining

pins on either side then pulling the air filter housings back

to separate them from the grommets on the front bumper.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 30 31

Keine Kommentare

Chevrolet CORVETTE Z06 - 2010 Bedienungsanleitung Seite 10