Chevrolet CORVETTE Z06 - 2010 Bedienungsanleitung PDF herunterladen (Seite 24)

Part #1572 & 1573

Brochure #63-1572

Rev. 1/11 - AJ/mc

Edelbrock GM LS7 Supercharger System for

2006 - 2010 Z06 Corvettes

Installation Instructions

Page 23

168. Attach the dry sump breather hose assembly to the

driver side valve cover fitting, then route the rest of the

hose along the firewall and over to the passenger side.

Connect the middle hose section to the passenger side

valve cover provision and the straight fitting to the rear

dry sump tank fitting.

169. Remove the tape covering the intake ports and,

preferably with the assistance of one or more people, lift

the supercharger assembly onto the engine.

170. Tilt the manifold back slightly to install the small

factory vacuum hose running from the driver side firewall

fitting on the small fitting on the driver side of the air inlet

and the brake booster hose onto the larger fitting then

secure the brake hose with a clamp supplied in Bag #2. If

the smaller hose is not present, leave the fitting capped.

171. Use a 10mm universal socket with an extension bar

to install the eight intake manifold bolts following the

torque sequence below. Torque the bolts to 4 ft-lbs in the

first pass, then to 7.5 ft-lbs in the second.

172. Use a 3/8" Fuel Line Removal Tool to remove the

fuel input line from the firewall fitting.

173. Take the fuel injectors out of their boxes and remove

their protective covers.

174. Apply o-ring lube to the upper injector seals, then

slide the injectors into the rails so that the electrical

connectors face away from the mounting flange.

175. Apply o-ring lube to the sealing ring of the four

supplied fuel rail fittings. Use a 3/4” wrench to install the

two straight hose fittings on the radiator side of each fuel

rail then install the plug in the firewall end of the

passenger side fuel rail and the U-shaped fitting on the

firewall end of the driver side rail. Orient the fitting close

to the injector, leaving room for the injector connector.

176. Connect Manifold to EVAP Solenoid hose to the outer

EVAP solenoid fitting and EVAP Solenoid to Firewall Hose

to the inner EVAP solenoid fitting. Route the Solenoid to

Firewall hose beneath hub snout and along driver side

valve cover to firewall fitting and connect it.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 30 31

Kommentare zu diesen Handbüchern

Keine Kommentare

Chevrolet CORVETTE Z06 - 2010 Bedienungsanleitung Seite 24

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Autos Chevrolet CORVETTE Z06 - 2010