Chevrolet 2009 Silverado 1500 Pickup Spezifikationen PDF herunterladen (Seite 184)

100

101

To adjust a tie-down, pull the locator pin out and move

the tie-down to another location making sure the

locator pin lines up with a locator hole on the rail. The

tie-down pin may not be installed correctly if the pin does

not line up, turn it over and reinstall. The tie-down will

not move when the pin is completely installed. The

maximum load for each rail is 500 lbs (227 kg).

The rails are notched at each end which allows the

tie-downs to be removed and placed on another rail. To

remove, pull the locator pin out and slide the tie-down

to the end of the rail and pull back.

To remove or install cargo tie-downs at the front of the

bed, slide the corner cap towards the center of the

bed to expose the rail notches. To remove the corner

cap, pull either edge away from the rail.

To remove the system, loosen the toggle bolts on each

rail until they can be removed from the bed of the

truck. To replace the system, place the toggle bolts and

rails into their original locations and tighten them to a

torque setting of 12.5 ft lbs (17 Y ).

If the system is removed to install a bed liner, make

sure there is no bed liner material in the installation

points.

Notice: If cargo is tied down using the horizontal

slots on the top of the pickup box, the box could be

damaged. Using the horizontal slots on the top of

the pickup box for tie-down locations may cause

damage to the pickup box and would not be covered

by the vehicle warranty. Only use the tie-down

loops if the vehicle does not have the cargo

management system.

2-84

1 2 ... 179 180 181 182 183 184 185 186 187 188 189 ... 597 598

Kommentare zu diesen Handbüchern

Keine Kommentare

Chevrolet 2009 Silverado 1500 Pickup Spezifikationen Seite 184

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Auto-Videosysteme Chevrolet 2009 Silverado 1500 Pickup