Chevrolet CORVETTE Z06 - 2010 Bedienungsanleitung PDF herunterladen (Seite 23)

Part #1572 & 1573

Brochure #63-1572

Rev. 1/11 - AJ/mc

Edelbrock GM LS7 Supercharger System for

2006 - 2010 Z06 Corvettes

Installation Instructions

Page 22

157. Use a 10mm socket to loosen rear hood hold down

latch bolt on passenger side fender.

158. Install intercooler reservoir by working molded hose

down along the passenger side of the radiator to the

water pump inlet and secure the hose on the pump fitting

with a hose clamp supplied in Bag #2.

159. Slide intercooler reservoir brackets behind loosened

fuse box nut and hood hold down latch bolt. Use a 10mm

socket to torque them to 89 in-lbs.

160. Use a 10mm socket to mount fuse on fuse box stud.

161. Use a 13mm socket to attach the harness power

wire to the main positive terminal.

162. Use a 10mm socket to attach the ground wire to the

ground stud near the relay.

163. Reinstall the fender well fuse box bolt.

164. Install supplied 15/32” hose on brake booster and

secure fitting with a hose clamp supplied in Bag #2.

165. Install the stock o-ring port gaskets in the

supercharger manifold.

166. Install supplied Manifold to EVAP Solenoid Hose on

manifold fitting below hub snout.

167. Clear engine valley of any hoses, wires, tools, etc.

Lay the intercooler-to-reservoir tank hose in the engine

bay, routed along the firewall behind the oil pressure

sensor, and connect it to the intercooler reservoir inlet,

securing the fitting with a hose clamp supplied in Bag #2.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 29 30 31

Keine Kommentare

Chevrolet CORVETTE Z06 - 2010 Bedienungsanleitung Seite 23