Chevrolet CORVETTE Z06 - 2010 Bedienungsanleitung PDF herunterladen (Seite 27)

Part #1572 & 1573

Brochure #63-1572

Rev. 1/11 - AJ/mc

Edelbrock GM LS7 Supercharger System for

2006 - 2010 Z06 Corvettes

Installation Instructions

Page 26

198. Remove the upper radiator hose to install the

serpentine belt

199. Route the serpentine belt according to the diagram.

Note that you must slide the belt around the bottom of the

bracket to get the belt on the lower passenger side idler

pulley.

200. Use a breaker bar and a 16mm socket to push the

tensioner enough to get the belt on, then double check the

routing.

201. Line up the tee fitting on the end of the oil cooler

outlet hose with the upper radiator hose. Cut the radiator

hose at the base of the barb on each side and discard the

section in beween.

202. Attach the radiator hose sections to both sides of the

tee and secure them with hose clamps. Attach the hose

to the radiator and secure it with a clamp.

203. Use a 10mm socket and the two stock bolts to

reinstall the radiator fan.

204. Attach the radiator fan electrical connector then

push the stock hoses back into the factory clips.

205. Use a 10mm socket, an extension bar, the four stock

bolts and the OEM o-ring seal to install the throttle body.

Torque the bolts to 91 in-lbs.

206. Connect ETC harness to the throttle body motor.

207. Connect the intercooler hose assembly to the two

upper hose fittings at the front of the manifold.

208. Install the silicone inlet tube to the throttle body and

secure it with a supplied worm clamp.

1 2 ... 22 23 24 25 26 27 28 29 30 31

Keine Kommentare

Chevrolet CORVETTE Z06 - 2010 Bedienungsanleitung Seite 27