Chevrolet CORVETTE Z06 - 2010 Bedienungsanleitung PDF herunterladen (Seite 30)

246. Return the dipstick to the dipstick tube.

247. Install the driver side coil cover by sliding it into

place and pressing the ball studs into bracket grommets.

248. Congratulations on the installation of your new

Edelbrock E-Force Supercharger System. If you have any

questions, please call our Technical Support hotline and

one of our technicians will be happy to assist you.

Part #1572 & 1573

Brochure #63-1572

Rev. 1/11 - AJ/mc

Edelbrock GM LS7 Supercharger System for

2006 - 2010 Z06 Corvettes

Installation Instructions

Page 29

237. Use directional pad to highlight your vehicle and

transmission combination then press Select, again.

238. Use directional pad to highlight Begin Program then

press Select.

239. Vehicles equipped with a manual transmission will

have three separate operations take place during this

step, while vehicles with an automatic transmission will

have five. Completion of each operation will cause the

progress bar to reset to zero.

DO NOT unplug the programmer until prompted.

240. Turn the car off when propted to do so by the

handheld programmer.

241. Read parting message from programmer then press

Select to continue.

242. Unplug the programmer cable from the OBD-II port.

243. Start the car and allow it to idle while closely

inspecting the engine bay for any fuel or coolant leaks.

Repair any leaks before operating vehicle!

244. Remove the engine oil dipstick.

245. Slide the supplied grommet into the passenger side

coil cover hole and lubricate it with silicone spray. Install

the passenger side coil cover by sliding the grommet

down and around the dipstick tube and pressing the ball

studs into the bracket grommets.

1 2 ... 25 26 27 28 29 30 31

Keine Kommentare

Chevrolet CORVETTE Z06 - 2010 Bedienungsanleitung Seite 30